Open Programmer v 0.8.x USB Version for EEproms

Quick facts

* Completely free and Open Source (including firmware)
* Programs PIC10-12-16-18-24, dsPIC30-33, EEPROMs type 24xxxx (I2C), 25xxx (SPI), 93xx6 (MicroWire), DS24xx (OneWire), 11xxx (UNIO), some ATMEL micros, communicates with generic I2C & SPI devices (see supported devices)
* Can work as ICD debugger
* USB 2.0 Full Speed interface, HID class (same as keyboards, mice, etc.)
* Self powered
* Doesn't need drivers
* Built from easy to find components (estimated cost ~10€)
* Hardware generated timings for maximum speed and reliability (writes a 18F2550 in 15s, 8s under Linux)
* Doesn't saturate your CPU and doesn't suffer when other programs are running
* Open source control programs for Linux and Windows
* It's not another PicKit clone

https://i.servimg.com/u/f60/16/90/43/07/foto210.jpg

ok po kya to

yes its a good starting point

source of the project - http://openprog.altervista.org/OP_eng.html

mga master,sinubukan kung gumawa yan noon pero hindi gumana sa ponyprog di lang ako sure baka may mali ako sa layout pero umi ilaw naman pag e click ko ang read,ang nilagay ko 24cxx.

Hindi naman yata pony ang gamit na soft diyan? Meron yan yatang sariling program.

mukhang di nga pwde sa pony.. based sa link ni Pi.. iba ang GUI nya OpenProg at Opgui

Haissst dami ko ng susubukan gawin. kayanin kaya ng limited budget ko.

nice one..hangang ngayon hinde pa ako naka gawa neto na version..

Gawa na sir.  

Your next in my todo list. Just wait here.  

may lay out nba jau nito mga master?

Sa website niya kumpleto.

ok..
naa nkoy blang PCB...
mag buhat ko ana,,|

soon ...